MFlenses - Una nueva vida en la era digital
MFLenses 2026

Foro de objetivos de enfoque manual

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.
Destacado

Espacio de socio destacado en la portada del foro.

Printing in Winter
Ver tema anterior :: Ver tema siguiente  


Reply

Another thing I learned: printing in winter bites.
Trying to keep the dishes at 24° C when your room is at 19° C is an annoying task.
And if you don't manage to keep dish temperature at 24°, the print is revealed, but the contrast control goes whacko and the print looks rubbish Mad


Reply

Orio escribió:
Another thing I learned: printing in winter bites.
Trying to keep the dishes at 24° C when your room is at 19° C is an annoying task.
And if you don't manage to keep dish temperature at 24°, the print is revealed, but the contrast control goes whacko and the print looks rubbish Mad


Well I used to use a long "hot plate" can't remember the proper name for it, also it might have been originally used for glazing/drying prints...anyway it had a thermostat control like a toaster, it was hot enough when switched to max for colour work.


Editado por última vez por Excalibur el Lun Ene 18, 2010 11:17 pm; editado 1 vez en total


Reply

Excalibur escribió:

Well I used to use a long "hot plate" can't remember the proper name for it...anyway it had a thermostat control like a toaster, it was hot enough when switched to max for colour work.


yeah, I found them for sale... but 180 Eur for one of them is a bit too much even for my wish to fix the problem.


Reply

Orio escribió:
Excalibur escribió:

Well I used to use a long "hot plate" can't remember the proper name for it...anyway it had a thermostat control like a toaster, it was hot enough when switched to max for colour work.


yeah, I found them for sale... but 180 Eur for one of them is a bit too much even for my wish to fix the problem.


Well looked up in my 1967 catalogue and it was called a "Photax dishwarmer" and then it was £6, well it still works now after this time.
Another make in those days was Pressman.


Reply

I gave up trying to print in the winter. My setup is in my basement which stays at a brisk 12.5°C around this time of year. I tried it once and by the time I came up I could hardly move, and there was no consistency to any of the prints. Hope you can find some work-around! Maybe a good space-heater? If I remember correctly your darkroom is a nice smaller area, correct?


Reply

Which paper and developer are you using, Orio? I've always developed RC papers (Ilford, Agfa, Foma) at 20-22°C with no consistency problem (not enough experience with FB). Are you sure is a bath temperature problem? In my experience the contrast starts to go whacko when the developer is near exhaustion. With fresh solution is always consistent, the prints are maybe ugly but that's another story Smile . (I take for granted the paper is good too).

Cheers, Marty.