MFlenses - Una nueva vida en la era digital
MFLenses 2026

Foro de objetivos de enfoque manual

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.
Destacado

Espacio de socio destacado en la portada del foro.

Filter for fluorescent light (film photography)
Ver tema anterior :: Ver tema siguiente  


Reply

While the weather at the moment offers plenty of opportunities for outdoor photography, eventually November is going to come around which in this part of the world means no sun, gray skies, wind and rain. Long story short, I will probably be taking more and more pictures indoors, including places with fluorescent lighting.

For my digital camera this isn't a problem since the AWB takes care of it. However, in the past few months I have been exploring and enjoying film photography. A while back I took a few pictures under fluorescent lights with daylight balanced film and the results were as I had expected: green. My understanding is that you "need" an FLD (?) filter / magenta filter to correct for this.

Question is this: Since the local (online) camera stores don't carry these anymore, I will probably have to resort to eBay. I have found a few no-brand FLD filters, but to be honest I am a bit hesitant about putting a no-brand filter in front of my lens. Any recommendations or alternatives short of scanning and correcting in post?

Regards, C.


Reply

A little more searching goes a long way. Just found that Hoya makes FL-D and FL-W filters. This is a company I know and trust.

Regards, C.


Reply

connloyalist escribió:
A little more searching goes a long way. Just found that Hoya makes FL-D and FL-W filters. This is a company I know and trust.

Regards, C.


Be sure to let us know how this works for you.

I'm not sure if you are going to find processing that won't require a little in-put from you- old style chemical printed prints are getting harder to obtain.
If you do go the scanning route, be sure to let the processor know you are shooting under fluorescent light with a compensating filter.

-D.S.