MFlenses - Una nueva vida en la era digital
MFLenses 2026

Foro de objetivos de enfoque manual

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.
Destacado

Espacio de socio destacado en la portada del foro.

Konica Pearl III, HELP needed with rangefinder adjustment
Ver tema anterior :: Ver tema siguiente  


Reply

Just acquired the Pearl III and I have found that the rangefinder is not reporting the correct distance, not even close. I guess I've been lucky because the Pearl is the fifth old rangefinder I have purchased and its the first one noticably off.

Checking around the internet I can find nothing specific to adjusting the rangefinder on Konica Pearl's. So I plunged ahead and removed the top plate and found two screws just behind (closer to the film side) the 45° mirror that is just behind the rangefinder opening (not the viewfinder opening). The screw just behind the mirror adjusted the vertical. The screw behind that adjusted the horizontal. Got it all adjusted at about 8 feet and felt very proud of myself, but then discovered the rangefinder did not converge at infinite. Getting that correct made the close focus off. From what I have read on various forums it seems there are at least two adjustment screws: one for close and one for infinite. But what have I adjusted? Close or infinite? And where is the opposite adjustment screw?


Reply

Welcome ricklb55. Any luck?


Reply

No luck. I tested all my other rangefinder cameras against a known distance and almost all of them were off. Some of them are close enough to fall within the DOF but nevertheless I have decided to use a separate rangefinder device that has tested dead on accurate, AND its easily adjusted, and transfer that distance to my rangefinder cameras.