MFlenses - Una nueva vida en la era digital
MFLenses 2026

Foro de objetivos de enfoque manual

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.
Destacado

Espacio de socio destacado en la portada del foro.

Nikon F
Ver tema anterior :: Ver tema siguiente  


Reply

An attic find, a Nikon F from 1962 with a Nikkor-S 2/50, which cannot be adapted to an EOS dSLR.


(photo taken with a CZ 1.4/50 at f/11)


(photo taken with a pinhole body cap on 5D, 30s at ISO800. It seems that the sensor needs cleaning Sad This is a down-sampled full frame after some PP.)

Veijo


Reply

vilva escribió:
... with a Nikkor-S 2/50, which cannot be adapted to an EOS dSLR.

Why not?

BTW, I have never seen a sensor that did not look dirty when used with a pinhole. Wink


Reply

LucisPictor escribió:
vilva escribió:
... with a Nikkor-S 2/50, which cannot be adapted to an EOS dSLR.

Why not?)


The aperture ring forms a collar protruding about 2.5mm. This prevents the lens from reaching deep enough to lock in the adapter or even reaching infinity focus on an EOS body. Of course, it would be possible to modify the ring, but I haven't been willing to resort to that as I have many enough fine, usable 50mm lenses.

Veijo


Reply

Ah, OK. I was asking because I have a Nikkor-H 2.0/50 and this one can easily be adapted to EOS.


Reply

vilva escribió:
An attic find, a Nikon F from 1962 with a Nikkor-S 2/50, which cannot be adapted to an EOS dSLR.


(photo taken with a CZ 1.4/50 at f/11)


(photo taken with a pinhole body cap on 5D, 30s at ISO800. It seems that the sensor needs cleaning Sad This is a down-sampled full frame after some PP.)

Veijo


nice camera.


Reply

vilva escribió:
An attic find, a Nikon F from 1962 with a Nikkor-S 2/50, which cannot be adapted to an EOS dSLR.


hm ... perhaps if you modify the adapter itself?
A lot of adapters consist of 2 pieces, the part that installs into the Canon body and one part that mimicks the nikon body mount.