MFlenses - Una nueva vida en la era digital
MFLenses 2026

Foro de objetivos de enfoque manual

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.
Destacado

Espacio de socio destacado en la portada del foro.

Adding a shim to an adapter
Ver tema anterior :: Ver tema siguiente  


Reply

I've just brought a 10mm UWA lens (in Sony A mount) and an adapter to fit it on micro four thirds.
As is common with cheap adapters it's been made slightly short to ensure infinity focus is maintained.
Unfortunately with such a short FL lens this error is significant I need to turn the focusing ring nearly all the way to closest focus to bring the actual focus down to infinity!
the DOF is such that I can get most shots in adequate focus by shutting down the aperture to around F8, but I'd like to have some focus movement available!
From what I've found on the internet relevant BFLs are:
Sony A 44.5mm
µ4/3 19.25mm
While my vernier calipers indicate the adapter is ~23.2mm

From these measurements adding 2 mm of shims under the body mount in the adapter should pretty much correct matters. That seems rather a lot to me, about 10 times what I would have expected.

Before I get going

Can anyone familiar with these shimming operations suggest any tips or ideally a complete procedure?
What are the best materials to use for shims?
Can anyone find fault with my calculations??

Many thanks
Mike


Editado por última vez por DConvert el Jue Nov 05, 2015 2:12 pm; editado 1 vez en total


Reply

2mm does seem like a lot of shim.

Tissue, Paper, Cardboard, etc., are easy to make into shims for testing...

For final, copper sheathing works great. Obtain different thicknesses at building supply hardware. Or Arts & Crafts Supply.


Reply

visualopsins escribió:
2mm does seem like a lot of shim.

Tissue, Paper, Cardboard, etc., are easy to make into shims for testing...

For final, copper sheathing works great. Obtain different thicknesses at building supply hardware. Or Arts & Crafts Supply.


Thanks. Thank you!

A quick trial with paper (0.1mm thickness) made no noticable difference. Using aq piece of card from a document wallet (0.35mm thick) has moved infinity focus about half way round the focusing ring, so hopefully double that thickness will get it right.

FWIW using a ink pad for rubber stamps made it much easier to mark out the shims for cutting. I'm not sure I'd want to try that if working from a lens but the adapter has nothing that will get damaged by the ink.


Reply

DConvert escribió:
...
FWIW using a ink pad for rubber stamps made it much easier to mark out the shims for cutting. I'm not sure I'd want to try that if working from a lens but the adapter has nothing that will get damaged by the ink.


brilliant!