MFlenses - Una nueva vida en la era digital
MFLenses 2026

Foro de objetivos de enfoque manual

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.
Destacado

Espacio de socio destacado en la portada del foro.

127 film cut from 120 rollfilm
Ver tema anterior :: Ver tema siguiente  


Reply

http://www.youtube.com/watch?v=o-HLR-k_qOE


Reply

all amazing ideas are the most simple.. as is this one:) thanks for sharing!


Reply

Sound idea!. Thanks for sharing Smile

Jes.


Reply

good idea, but how's he get it onto a 127 spool. I tried respooling 120 onto a 620 spool once and it was a nightmare


Reply

philslizzy escribió:
good idea, but how's he get it onto a 127 spool. I tried respooling 120 onto a 620 spool once and it was a nightmare


I think same night mare in darkness...

to 620 I simple clip a 120 roll with strong nail clipper, difference only between them 120 spool has larger diameter at ends.


Reply

Attila escribió:

I think same night mare in darkness...

to 620 I simple clip a 120 roll with strong nail clipper, difference only between them 120 spool has larger diameter at ends.


perhaps but its thicker in the middle too and the hole in the spool is smaller on a 620. However your nail clipper method works?


Reply

yes, works well in Kodak Monitor no issue.


Reply

Mark film a bit smaller 2mm at least than normal 127 due you can't cut perfectly. Do it in total dark, to be sure edges not get light. Start with cigar cutter , but finish it with sharp knife, cutter not cut straight well. Re-spool it to 127 spool.