MFlenses - Una nueva vida en la era digital
MFLenses 2026

Foro de objetivos de enfoque manual

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.
Destacado

Espacio de socio destacado en la portada del foro.

KIRON 1:1 macro 105mm (100mm) repair
Ver tema anterior :: Ver tema siguiente  


Reply

I bought a lens with stuck focusing. I was able to release it but now it's shaky. The reason is probably screw got loosen inside due to much force used to focus. Problem: i cannot remove label ring to open from front side and reach two screws on photo. I'd appreciate good advice.



Reply

Pack barrel in dry ice while warming label ring with hair dryer, shrinking the former while expanding the latter. Hope it's enough so it becomes possible to separate them. Once apart, repair damage to allow future re-assembly/dis-assembly without resort to such extraordinary measures.


Reply

guardian escribió:
Pack barrel in dry ice while warming label ring with hair dryer, shrinking the former while expanding the latter. Hope it's enough so it becomes possible to separate them. Once apart, repair damage to allow future re-assembly/dis-assembly without resort to such extraordinary measures.


Splendid advice. I'll try. Thanks!


Reply

Didn't work. Next step Smile - see the photo. I know it looks ugly but it was necessary procedure. This was condition to remove focusing ring. And under were the holders i needed to tighten.

Posted is also photo of aperture manipulator, it has prepared different values for other mount probably. M for Minolta...