MFlenses - Una nueva vida en la era digital
MFLenses 2026

Foro de objetivos de enfoque manual

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.
Destacado

Espacio de socio destacado en la portada del foro.

CZJ Tessar 2.8/50 disassembly
Ver tema anterior :: Ver tema siguiente  


Reply

I'm trying to repair my CZJ Tessar, but I can't find a proper tutorial as none of the repaired lenses in those tutorials seem to have been built like mine.
I only managed to remove the back and the focus ring and now I'm stuck.
Any advice on how should I proceed if I'm to disassemble it whole?

Here are the pictures:









I tried these advices, but none of them helped.

http://oomz.net/tessar/

http://forum.mflenses.com/how-to-tessar-disassembly-t30506.html

http://forum.mflenses.com/viewtopic.php?t=21037&view=previous


Reply

Hi,

If i remember well, you have to unscrew the front name ring to expose the notches that will allow you to unscrew the front optical group ...

Hope this helps ...


Reply

I saw your set on Flickr, but I'm not sure how does a sink cap apply on the front element (which is a bit different than mine).
Edit: I can actually move plastic "filter" just above the front lens glass,below the name plate, but it only moves till a certain point where it stops.


Reply

please look here:
http://forum.mflenses.com/how-to-put-my-czj-50-2-8-together-t23316.html
and here:
http://forum.mflenses.com/tessar-50mm-alu-reassembly-t11938.html


start to unscrew the ring at rear part.
(photo, in which you hold your tessar Wink )


Reply

I did it. Now I only have to reassemble it. Shocked


Reply

Fine, good news ...