MFlenses - Una nueva vida en la era digital
MFLenses 2026

Foro de objetivos de enfoque manual

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.
Destacado

Espacio de socio destacado en la portada del foro.

Ultrafin Liquid and Formapan 200 - How many agitations?
Ver tema anterior :: Ver tema siguiente  


Reply

I've found the devolopment time of 7.5min @ 20°C on the net.
But nowhere is mentioned how many agitations have to be used at this time.

Is anybody experienced with that combination?


Reply

I have not tried this combination but I used Ultrafin extensively some years ago, but I can give you some general observations.

Ultrafin is a developer which needs some care to use, especially agitation. A well-known British photographer used it later in her life and could not master it as it can give mottled greys. The only practical way to use it is to use a processing tank twice the size of what the film takes up. For instance, with a tank that takes 120 or two 35mm reels, put in only one 35mm reel, and put in just enough solution to cover the reel. Keep the inside air space at least as much as the solution inside, and also make sure the reel is clamped to the bottom of the tank.

When you invert the tank for agitation, the film would be completely drained from the solution, and the solution gets thoroughly mixed, so when you put it right way up again, a uniform solution is applied to the film surface. Failing to do that, you will get mottling in the areas with uniform tones.

My way of agitation is every half minute and it worked quite well. Do be aware that Ultrafin is indeed a fine-grain developer, producing somewhat mushy grain patterns, quite the opposite of Rodinal. I also found the resultant negatives to be a little on the thin side, so you can use the published time as a starting point, and then do your own fine-tuning to suit your own system. Good luck.


Reply

Hi

there 3 general "offical" methods as a starting point :

agfa ( the one i use ) : continous agitation for the 1 minute, then one every 30sec then comes

ilford method : 4 times during the first 10 sec then every minute

fuji : 5 agitation during every 30 secs


That said, it's up to you, remember to use the same method for fixing, and once you ' ve found the method that gives the best results and suits you stick to it !

by now i prefer stirring, much better and regular results, just because it's more relaxing and the film is always in the liquid. i said this because with shaking the tank i had unpleasant undeveloped parts of film

good luck , it's worth it : )


Reply

hexi,

If you have left enough air space inside the tank, then the number of inversion at every agitation cycle is not really important, as the solution is thoroughly mixed to disperse bromine and developing agent evenly. In fact, if you give vigorous agitation which takes up a greater percentage of overall processing time, you might run into bromine drags.

Decades ago Jobo published a paper on the inherent pitfalls with spinning the spiral only, and that was before the common adoption of inversion agitation. The tank Jobo produced also incorporate an up-and-down movement as well, and some other tanks also did that, like one I used to use which makes the spiral hops up and down when spinning it. Inversion agitation changed everything, of course: when I was instructing students and if they used Paterson tanks, the first thing I did was to confiscate their stirring sticks!


Reply

Thank you Smile