MFlenses - Una nueva vida en la era digital
MFLenses 2026

Foro de objetivos de enfoque manual

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.
Destacado

Espacio de socio destacado en la portada del foro.

Guide on adjusting the tightness of bayonet type adaptor
Ver tema anterior :: Ver tema siguiente  


Reply

Some cheap and expensive bayonet adaptor from China will need an adjustment. If your adaptor cannot lock the lens well, you may try the following.

1. Prepare a flat tip screw driver and an adapor. I use a OM to EOS adapotor here. You will need to adjust three places marked with red arrows.


2. Insert the screw driver to the small gap as shown below. Rotate the screw driver. Repeat this to other locking mechanism.



3. Test the adaptor with your lens. Repeat the above step if nessary.


4. Done. Enjoy your adaptor.


Reply

Possibly the best piece of camera-related advice I've seen on the web! Very Happy


Reply

rawhead escribió:
Possibly the best piece of camera-related advice I've seen on the web! Very Happy

Very Happy


Reply

+1 thank you!


Reply

This works as long as you don't mount and unmount lenses on the adapter too often. The more often you change lenses, the less tight the adapter will become again. So it's best to have a dedicated adapter for every lens and not take the adapter off at all.