This is in Exakta mount, and i was able to unscrew the mount off after unscrewing the 3 small screws on the flange neck right under the Exakta flange. Having done that I found that it was constructed very differently inside from other Exakta mounts I have seen; the lens mount besides being screwing down -was screwed by the 3 small screws I mentioned before to an inner sleeve . This sleeve does not rotate as it has a slot that makes it slide in and out, but not around.
The throat i.e. the part that the Exakta mount screws on is akin to a uni-adapter .Its a tad wider than a T-mount,and a tad smaller than a T-mount with the inner ring removed.
The main objective of all of this was to see how I could convert to or mount a M42 mount, and maintain infinity. Shaving the back of the mount is out of question as the back of the mount is thin enough where shaving maybe ill advised.
I have posted some images of the partial disassemble-I am keen on hearing what your experience/advise/suggestions may be, specially if you've had a similar lens you've worked on
Whats the diameter of the thread ? _________________ I like Pentax DSLR's, Exaktas, M42 bodies of all kinds, strange and cheap Japanese lenses, and am dabbling in medium format/Speed Graphic work.
The diameter of the inner threaded end is 44mm
Thanks
P.S-Check my other new old lens a SUN ,Linked here -looks like following your lead .Although I know I could never never produce the quality of images you do-they're super.
Its got a focus ring that wont budge so far. I've managed to loosen and free up the aperture blades. I was able to test it mounted on bellows -it actually works quite good and with infinity and a much closer "close focusing" distance.
pps-edited stuff about miranda mount out-too much happy sauce when I wrote that
No puedes publicar temas nuevos en este foro No puedes responder a temas en este foro No puedes editar tus mensajes en este foro No puedes borrar tus mensajes en este foro No puedes votar en las encuestas de este foro