MFlenses - Una nueva vida en la era digital
MFLenses 2026

Foro de objetivos de enfoque manual

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.
Destacado

Espacio de socio destacado en la portada del foro.

Scanning pictures: HP Scanjet 2400
Ver tema anterior :: Ver tema siguiente  


Reply

Hi colleagues,

Having went back to film, I need to scan the pictures (to store digitally and to be able to show them to you Wink ).

So I took the dust out of my cheap flatbed scanner and started scanning some of the Konica C35 pictures I took to test the camera.

The default setting for the scanner are to scan pictures at 200 dpi. That seemed to me not too high, so I tried to push the scanner to its limits and set 4800 dpi.

The resulting file was a 1,5 Gb file... Not manageable.

So my question is, which is the appropriate resolution to scan 11x13cm pictures?.

Thanks in advance.
Jes.

200 dpi samples:





(Notice the reddish flame caused by the defective seal.)


Reply

Jesito escribió:

So my question is, which is the appropriate resolution to scan 11x13cm pictures?.


For printing a 10x15 cm photograph, a 300 PPI scan or perhaps even a 240 should be enough.


Reply

Orio escribió:
Jesito escribió:

So my question is, which is the appropriate resolution to scan 11x13cm pictures?.


For printing a 10x15 cm photograph, a 300 PPI scan or perhaps even a 240 should be enough.


Thanks, Orio!
I'll try it...
Best regards,
Jes.


Reply

Of course I am speaking of scanning an original of the same size.

I realized now you perhaps talk about scanning a negative or slide.

In that case, you will need a higher resolution. Usually scanners come with a managing program that lets you set the final output as pixels, inches and centimetres, so you should be able to set it to centimetres and set the precise value you need.