MFlenses - Una nueva vida en la era digital
MFLenses 2026

Foro de objetivos de enfoque manual

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.
Destacado

Espacio de socio destacado en la portada del foro.

Question about shim and focusing
Ver tema anterior :: Ver tema siguiente  


Reply

Let's say that I have a camera-lens combination that consistently focuses before the focused point.
Example (with fake numbers): I focus on a point which is at 10 meters from the camera, and the actual focus instead falls on a point that is 9 meters from the camera.
What should I do to improve on this, add a shim to the focusing screen, or remove a shim?


Reply

Have you tried removing the lens and adjusting the focus of the screen with the eyepiece adjustment ? I realize you said a particular lens/camera combination, but it might be worth a try.


Reply

greg escribió:
Have you tried removing the lens and adjusting the focus of the screen with the eyepiece adjustment ? I realize you said a particular lens/camera combination, but it might be worth a try.


Thanks Greg, I did it first thing.


Reply

Hi Orio,

I suppose that when you say

Orio escribió:

and the actual focus instead falls on a point that is 9 meters from the camera


you are talking about the focus confirmation led of your camera ...
In you case, i think you should add a shimmer between the focusing screen and the metal mask which holds it (i.e. tra lo schermo di messa a fuoco e la gabbia di metallo che lo sostiene), in order to slightly increase the focusing distance (you certainly know that the focusing screen is supposed to be at the same distance from the mirror than the CCD of your camera, but, due to tolerances, sometimes this is not true) ...

Hope this helps


Reply

This can be caused by three things in my experience:

1. Shim or metal clip holding the focus screen not clipped in properly, so the focusing screen is in the wrong position
2. Shim is bent
3. Focusing screen is inserted the wrong way round


Reply

indianadinos escribió:
Hi Orio,

I suppose that when you say

Orio escribió:

and the actual focus instead falls on a point that is 9 meters from the camera


you are talking about the focus confirmation led of your camera ...


No Indiana, I am talking of the actual focus.
I am not using the led.
I focus manually to a given subject (example: at 10 meters), I shoot, and when I verify the image, the actual focus fell on (for example) 9 meters.

In other words, the camera focused nearer than what I wanted.


Reply

I believe you need to put a shim under the focus screen to raise it slightly so that what you see matches what is recorded.

Which I think is what Indiana was talking about?