MFlenses - Una nueva vida en la era digital
MFLenses 2026

Foro de objetivos de enfoque manual

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.

Explora el mundo de los objetivos antiguos mediante notas de reparación, pruebas reales e hilos de archivo llenos de imágenes.
Destacado

Espacio de socio destacado en la portada del foro.

Step by step resassembly of the Ihagee original EXA - III
Ver tema anterior :: Ver tema siguiente  


Reply

After some cleaning of all the debris and old lubricants, the reassembly follows the same steps in reverse, the final result look much cleaner than before:

#1 The shutter base looks clean, now the reassembly can start.



#2 Even the spacers look shiny.



#3 Install the left wing where the shutter lever goes.



#4 When placing this part, be careful of pressing the spring end behind





#5 Now place the shutter speed lever elements. There is a small spring wire that might be low of tension, adjust accordingly.





#6 Next place the shutter trigger lever and over it the mirror retainer.



Finally, place the two levers at the bottomside.
With this, we have again a working shutter mechanism.


Jes.


Reply

Wow! It is really clean! I can't wait for final result, how you can make from an orphan camera a new proud guy again!


Reply

We will name this camera 'Oliver' Very Happy

Looks much better in the reassembly than it did in the disassembly stage.


Reply

Laughing


Reply

maddog10 escribió:
We will name this camera 'Oliver' Very Happy

Looks much better in the reassembly than it did in the disassembly stage.


Good name!. It will keep it Smile.

Jes.